EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757179241	975 Count	404 Count	404 Count
1757177440	972 Count	402 Count	402 Count
1757175647	969 Count	400 Count	400 Count
1757173846	966 Count	398 Count	398 Count
1757172046	963 Count	396 Count	396 Count
1757170245	960 Count	394 Count	394 Count
1757168444	957 Count	392 Count	392 Count
1757166643	954 Count	390 Count	390 Count
1757164843	951 Count	388 Count	388 Count
1757163042	948 Count	386 Count	386 Count
1757161241	945 Count	384 Count	384 Count
1757159441	942 Count	382 Count	382 Count
1757157640	939 Count	380 Count	380 Count
1757155839	936 Count	378 Count	378 Count
1757154047	933 Count	376 Count	376 Count
1757152246	930 Count	374 Count	374 Count
1757150446	927 Count	372 Count	372 Count
1757148645	924 Count	370 Count	370 Count
1757146844	921 Count	368 Count	368 Count
1757145044	918 Count	366 Count	366 Count
1757143243	915 Count	364 Count	364 Count
1757141442	912 Count	362 Count	362 Count
1757139641	909 Count	360 Count	360 Count
1757137841	906 Count	358 Count	358 Count
1757136040	903 Count	356 Count	356 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)