EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8RPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8RPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777458370	197 Count	445 Count	188 Count
1777455983	118 Count	295 Count	114 Count
1777451180	21 Count	52 Count	21 Count
1777448778	340 Count	984 Count	319 Count
1777446377	300 Count	880 Count	281 Count
1777443975	256 Count	773 Count	239 Count
1777441572	213 Count	667 Count	198 Count
1777439170	186 Count	567 Count	173 Count
1777436769	145 Count	424 Count	135 Count
1777434382	106 Count	304 Count	101 Count
1777431981	76 Count	205 Count	73 Count
1777429579	38 Count	105 Count	37 Count
1777427177	327 Count	1013 Count	302 Count
1777424776	297 Count	913 Count	274 Count
1777422374	256 Count	808 Count	235 Count
1777419971	223 Count	716 Count	204 Count
1777417569	189 Count	633 Count	172 Count
1777415168	161 Count	546 Count	147 Count
1777412781	133 Count	462 Count	124 Count
1777410379	111 Count	387 Count	104 Count
1777407978	93 Count	308 Count	88 Count
1777405579	66 Count	211 Count	63 Count
1777403174	35 Count	119 Count	34 Count
1777398370	355 Count	847 Count	338 Count
1777395969	304 Count	715 Count	289 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)