EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SK3VJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SK3VJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777793781	6 Count	40 Count	6 Count
1777790175	215 Count	991 Count	185 Count
1777788372	207 Count	952 Count	178 Count
1777786569	198 Count	913 Count	170 Count
1777784766	189 Count	873 Count	162 Count
1777782963	179 Count	826 Count	153 Count
1777781160	170 Count	783 Count	145 Count
1777779357	161 Count	742 Count	137 Count
1777777554	151 Count	701 Count	128 Count
1777775751	141 Count	657 Count	119 Count
1777773948	132 Count	610 Count	111 Count
1777772178	119 Count	573 Count	103 Count
1777770375	109 Count	532 Count	94 Count
1777768572	100 Count	492 Count	86 Count
1777766769	92 Count	446 Count	79 Count
1777764966	84 Count	402 Count	72 Count
1777763163	75 Count	361 Count	64 Count
1777761360	65 Count	316 Count	55 Count
1777759557	56 Count	277 Count	47 Count
1777757754	46 Count	238 Count	38 Count
1777755951	36 Count	195 Count	29 Count
1777754148	26 Count	149 Count	20 Count
1777750575	8 Count	55 Count	8 Count
1777748772	182 Count	1043 Count	152 Count
1777746969	174 Count	996 Count	145 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)