EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SZ1SV-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SZ1SV-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777913297	564 Count	938 Count	484 Count
1777912394	559 Count	927 Count	480 Count
1777911491	550 Count	911 Count	472 Count
1777910588	532 Count	888 Count	455 Count
1777908782	514 Count	859 Count	439 Count
1777906073	480 Count	821 Count	408 Count
1777905167	475 Count	807 Count	404 Count
1777904266	468 Count	793 Count	398 Count
1777903362	456 Count	776 Count	387 Count
1777902458	448 Count	762 Count	380 Count
1777901554	442 Count	749 Count	375 Count
1777900651	434 Count	736 Count	368 Count
1777899748	427 Count	724 Count	362 Count
1777898845	419 Count	711 Count	355 Count
1777897942	414 Count	699 Count	351 Count
1777897039	409 Count	685 Count	347 Count
1777896136	403 Count	664 Count	342 Count
1777895234	396 Count	650 Count	336 Count
1777894330	391 Count	638 Count	332 Count
1777893427	384 Count	625 Count	326 Count
1777892524	375 Count	607 Count	318 Count
1777891621	368 Count	590 Count	312 Count
1777890718	367 Count	588 Count	312 Count
1777889815	355 Count	567 Count	301 Count
1777888912	348 Count	554 Count	295 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)