EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777793435	379 Count	658 Count	355 Count
1777792530	362 Count	630 Count	339 Count
1777791626	344 Count	604 Count	322 Count
1777790722	326 Count	579 Count	305 Count
1777789822	312 Count	556 Count	292 Count
1777788918	294 Count	531 Count	275 Count
1777788014	278 Count	506 Count	260 Count
1777787110	263 Count	483 Count	246 Count
1777786206	247 Count	456 Count	231 Count
1777785301	231 Count	425 Count	216 Count
1777784397	216 Count	402 Count	202 Count
1777783493	201 Count	377 Count	188 Count
1777782589	185 Count	351 Count	173 Count
1777781685	171 Count	324 Count	160 Count
1777780781	156 Count	294 Count	146 Count
1777779877	139 Count	270 Count	130 Count
1777778973	124 Count	240 Count	116 Count
1777778068	110 Count	213 Count	103 Count
1777777164	97 Count	183 Count	91 Count
1777776260	84 Count	159 Count	79 Count
1777775464	72 Count	135 Count	68 Count
1777774560	58 Count	110 Count	55 Count
1777773656	44 Count	82 Count	42 Count
1777772752	29 Count	57 Count	28 Count
1777771848	15 Count	27 Count	15 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)