EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1769982566	14 Count	29 Count
1769981963	13 Count	27 Count
1769981359	12 Count	27 Count
1769980756	11 Count	26 Count
1769980152	10 Count	23 Count
1769979549	9 Count	22 Count
1769978946	8 Count	20 Count
1769978342	7 Count	18 Count
1769977739	6 Count	16 Count
1769977136	5 Count	14 Count
1769976532	4 Count	11 Count
1769975929	3 Count	10 Count
1769975325	2 Count	7 Count
1769974722	1 Count	3 Count
1769974119	0 Count	1 Count
1769973515	485 Count	1003 Count
1769972912	484 Count	1000 Count
1769972308	483 Count	999 Count
1769971705	482 Count	997 Count
1769971102	481 Count	995 Count
1769970497	480 Count	992 Count
1769969894	479 Count	991 Count
1769969291	478 Count	988 Count
1769968687	477 Count	985 Count
1769968084	476 Count	984 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)