EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

YO8PIC-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8PIC-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1764841607	626 Count	680 Count	343 Count
1764841004	620 Count	674 Count	338 Count
1764840401	614 Count	667 Count	333 Count
1764839798	607 Count	660 Count	327 Count
1764839195	600 Count	653 Count	321 Count
1764838592	594 Count	647 Count	316 Count
1764837988	587 Count	639 Count	310 Count
1764837385	581 Count	632 Count	305 Count
1764836781	575 Count	626 Count	300 Count
1764836178	567 Count	617 Count	293 Count
1764835575	561 Count	612 Count	288 Count
1764834972	556 Count	607 Count	284 Count
1764834368	549 Count	600 Count	278 Count
1764833765	542 Count	592 Count	272 Count
1764833162	537 Count	587 Count	268 Count
1764832559	530 Count	579 Count	262 Count
1764831956	523 Count	571 Count	256 Count
1764831353	518 Count	566 Count	252 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)