EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1774214789	551 Count	876 Count	447 Count
1774212985	508 Count	809 Count	411 Count
1774211182	470 Count	748 Count	380 Count
1774209378	435 Count	689 Count	352 Count
1774207574	394 Count	625 Count	318 Count
1774205770	358 Count	567 Count	289 Count
1774203967	322 Count	514 Count	260 Count
1774202163	280 Count	439 Count	225 Count
1774200359	237 Count	373 Count	190 Count
1774198555	196 Count	306 Count	158 Count
1774191458	195 Count	306 Count	158 Count
1774189705	159 Count	257 Count	128 Count
1774187901	115 Count	189 Count	93 Count
1774186098	75 Count	125 Count	61 Count
1774184294	42 Count	62 Count	35 Count
1774182490	666 Count	1001 Count	541 Count
1774180687	624 Count	936 Count	506 Count
1774178883	585 Count	876 Count	474 Count
1774177076	547 Count	820 Count	444 Count
1774175272	510 Count	769 Count	414 Count
1774173469	480 Count	729 Count	393 Count
1774171663	441 Count	663 Count	361 Count
1774169858	405 Count	607 Count	332 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)