EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

4K6EH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6EH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777928243	392 Count	243 Count	111 Count
1777927340	387 Count	241 Count	110 Count
1777926436	383 Count	239 Count	109 Count
1777925533	378 Count	236 Count	108 Count
1777924629	374 Count	235 Count	107 Count
1777923726	369 Count	231 Count	106 Count
1777922823	365 Count	230 Count	105 Count
1777921919	360 Count	227 Count	104 Count
1777921015	356 Count	226 Count	103 Count
1777920112	351 Count	222 Count	102 Count
1777919209	341 Count	217 Count	98 Count
1777918305	298 Count	195 Count	78 Count
1777917399	266 Count	179 Count	63 Count
1777916495	263 Count	176 Count	62 Count
1777915593	261 Count	170 Count	61 Count
1777914773	256 Count	165 Count	60 Count
1777913869	252 Count	163 Count	59 Count
1777912966	247 Count	160 Count	58 Count
1777912062	243 Count	153 Count	57 Count
1777911159	238 Count	150 Count	56 Count
1777910255	234 Count	148 Count	55 Count
1777909352	231 Count	147 Count	55 Count
1777908449	227 Count	146 Count	54 Count
1777907545	222 Count	145 Count	53 Count
1777906642	218 Count	144 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)