EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

4K4AZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K4AZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1764908523	448 Count	443 Count
1764907620	447 Count	442 Count
1764906717	446 Count	441 Count
1764905814	445 Count	440 Count
1764904911	444 Count	439 Count
1764904008	443 Count	438 Count
1764903105	442 Count	437 Count
1764902202	441 Count	436 Count
1764901371	440 Count	435 Count
1764900468	439 Count	434 Count
1764899565	438 Count	433 Count
1764898662	437 Count	432 Count
1764897759	436 Count	431 Count
1764896856	435 Count	430 Count
1764895953	434 Count	429 Count
1764895050	433 Count	428 Count
1764894147	432 Count	427 Count
1764893244	431 Count	426 Count
1764892341	430 Count	425 Count
1764891438	429 Count	424 Count
1764890535	428 Count	423 Count
1764889632	427 Count	422 Count
1764888729	426 Count	421 Count
1764887826	425 Count	420 Count
1764886923	424 Count	419 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)