EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766701963	218 Count	246 Count	204 Count
1766700162	200 Count	226 Count	187 Count
1766698362	181 Count	202 Count	169 Count
1766696561	162 Count	180 Count	151 Count
1766694760	145 Count	159 Count	135 Count
1766692959	126 Count	138 Count	117 Count
1766691159	105 Count	115 Count	97 Count
1766689358	88 Count	95 Count	81 Count
1766687558	67 Count	71 Count	61 Count
1766685757	45 Count	46 Count	40 Count
1766683956	22 Count	20 Count	18 Count
1766682163	896 Count	1013 Count	846 Count
1766680362	863 Count	980 Count	814 Count
1766678561	843 Count	958 Count	795 Count
1766676761	826 Count	938 Count	779 Count
1766674961	808 Count	920 Count	762 Count
1766673159	781 Count	892 Count	736 Count
1766671359	758 Count	863 Count	714 Count
1766669558	738 Count	830 Count	695 Count
1766667757	722 Count	802 Count	680 Count
1766665957	703 Count	781 Count	662 Count
1766664156	678 Count	757 Count	638 Count
1766662355	660 Count	740 Count	621 Count
1766660562	641 Count	725 Count	607 Count
1766658761	630 Count	715 Count	597 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)