EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3HUO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773891827	973 Count	106 Count	100 Count
1773890026	968 Count	106 Count	100 Count
1773888225	964 Count	106 Count	100 Count
1773886453	960 Count	106 Count	100 Count
1773884652	955 Count	106 Count	100 Count
1773882851	950 Count	106 Count	100 Count
1773881050	945 Count	106 Count	100 Count
1773879249	941 Count	106 Count	100 Count
1773877448	937 Count	106 Count	100 Count
1773875647	932 Count	106 Count	100 Count
1773873846	928 Count	106 Count	100 Count
1773872045	923 Count	106 Count	100 Count
1773870243	919 Count	106 Count	100 Count
1773868442	914 Count	106 Count	100 Count
1773866641	909 Count	106 Count	100 Count
1773864840	904 Count	106 Count	100 Count
1773863038	900 Count	106 Count	100 Count
1773861237	895 Count	106 Count	100 Count
1773859436	891 Count	106 Count	100 Count
1773857635	885 Count	106 Count	100 Count
1773855833	878 Count	106 Count	100 Count
1773854032	860 Count	93 Count	87 Count
1773852231	852 Count	93 Count	87 Count
1773850429	848 Count	93 Count	87 Count
1773848628	839 Count	93 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)