EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PD1AQM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD1AQM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777912520	410 Count	161 Count	161 Count
1777910716	407 Count	159 Count	159 Count
1777908913	404 Count	157 Count	157 Count
1777907108	401 Count	155 Count	155 Count
1777905305	398 Count	153 Count	153 Count
1777903501	395 Count	151 Count	151 Count
1777901697	392 Count	149 Count	149 Count
1777899893	389 Count	147 Count	147 Count
1777898089	386 Count	145 Count	145 Count
1777896286	383 Count	143 Count	143 Count
1777894482	378 Count	139 Count	139 Count
1777892723	375 Count	137 Count	137 Count
1777890919	372 Count	135 Count	135 Count
1777889115	369 Count	133 Count	133 Count
1777887311	366 Count	131 Count	131 Count
1777885508	363 Count	129 Count	129 Count
1777883704	354 Count	121 Count	121 Count
1777881901	351 Count	119 Count	119 Count
1777880098	348 Count	117 Count	117 Count
1777878294	345 Count	115 Count	115 Count
1777876490	342 Count	113 Count	113 Count
1777874687	339 Count	111 Count	111 Count
1777872883	331 Count	104 Count	104 Count
1777871121	325 Count	99 Count	99 Count
1777869317	322 Count	97 Count	97 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)