EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9EPW-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9EPW-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777791531	99 Count	574 Count	76 Count
1777787938	85 Count	537 Count	68 Count
1777786137	79 Count	524 Count	63 Count
1777784336	74 Count	482 Count	59 Count
1777782536	68 Count	448 Count	54 Count
1777780734	60 Count	399 Count	47 Count
1777778933	54 Count	360 Count	42 Count
1777777132	48 Count	330 Count	37 Count
1777775331	43 Count	277 Count	33 Count
1777773531	38 Count	238 Count	29 Count
1777771731	32 Count	190 Count	24 Count
1777769929	26 Count	139 Count	19 Count
1777766339	10 Count	61 Count	9 Count
1777764538	4 Count	27 Count	4 Count
1777762738	261 Count	1015 Count	208 Count
1777760935	255 Count	987 Count	203 Count
1777759136	251 Count	975 Count	200 Count
1777755532	240 Count	950 Count	191 Count
1777753732	234 Count	939 Count	186 Count
1777751931	228 Count	929 Count	181 Count
1777750132	205 Count	903 Count	159 Count
1777748329	199 Count	886 Count	154 Count
1777746529	192 Count	869 Count	148 Count
1777742935	177 Count	843 Count	139 Count
1777741134	172 Count	832 Count	135 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)