EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769969952	416 Count	943 Count	277 Count
1769969051	413 Count	932 Count	275 Count
1769968209	406 Count	926 Count	273 Count
1769967309	403 Count	911 Count	271 Count
1769966408	400 Count	904 Count	269 Count
1769965507	396 Count	890 Count	266 Count
1769964607	392 Count	878 Count	263 Count
1769963706	388 Count	868 Count	260 Count
1769962806	385 Count	863 Count	258 Count
1769961905	382 Count	854 Count	256 Count
1769961004	379 Count	847 Count	254 Count
1769960104	376 Count	840 Count	252 Count
1769959203	373 Count	834 Count	250 Count
1769958303	370 Count	825 Count	248 Count
1769957402	367 Count	820 Count	246 Count
1769956501	364 Count	813 Count	244 Count
1769955601	361 Count	806 Count	242 Count
1769954700	358 Count	801 Count	240 Count
1769953799	354 Count	794 Count	237 Count
1769952899	351 Count	788 Count	235 Count
1769951998	347 Count	781 Count	232 Count
1769951098	344 Count	776 Count	230 Count
1769950197	341 Count	769 Count	228 Count
1769949296	338 Count	764 Count	226 Count
1769948396	334 Count	757 Count	223 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)