EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1773873917	247 Count	79 Count
1773873317	235 Count	75 Count
1773872716	222 Count	70 Count
1773872116	216 Count	69 Count
1773871516	203 Count	65 Count
1773870916	190 Count	60 Count
1773870316	184 Count	59 Count
1773869716	172 Count	55 Count
1773869116	155 Count	46 Count
1773868516	141 Count	43 Count
1773867916	122 Count	39 Count
1773867315	110 Count	35 Count
1773866715	103 Count	33 Count
1773866115	89 Count	28 Count
1773865515	72 Count	22 Count
1773864915	59 Count	19 Count
1773864315	52 Count	17 Count
1773863715	40 Count	12 Count
1773863115	27 Count	8 Count
1773862515	16 Count	5 Count
1773861914	1004 Count	413 Count
1773861314	992 Count	409 Count
1773860729	979 Count	405 Count
1773860129	963 Count	399 Count
1773859529	949 Count	395 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)