EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777812419	128 Count	212 Count	100 Count
1777811518	126 Count	208 Count	99 Count
1777810617	124 Count	203 Count	98 Count
1777809717	121 Count	196 Count	96 Count
1777808816	117 Count	191 Count	93 Count
1777807915	112 Count	184 Count	89 Count
1777807014	104 Count	175 Count	82 Count
1777806134	100 Count	167 Count	79 Count
1777805233	98 Count	164 Count	78 Count
1777804331	97 Count	159 Count	78 Count
1777803430	89 Count	150 Count	71 Count
1777802530	87 Count	143 Count	70 Count
1777801629	82 Count	135 Count	66 Count
1777800728	78 Count	129 Count	63 Count
1777799827	73 Count	121 Count	59 Count
1777798927	68 Count	111 Count	55 Count
1777798026	65 Count	104 Count	53 Count
1777797125	61 Count	96 Count	50 Count
1777796224	59 Count	91 Count	49 Count
1777795323	55 Count	87 Count	46 Count
1777794423	50 Count	80 Count	42 Count
1777793522	45 Count	74 Count	38 Count
1777792621	40 Count	67 Count	34 Count
1777791720	34 Count	58 Count	29 Count
1777790820	28 Count	49 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)