EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777792452	36 Count	606 Count	10 Count
1777791551	35 Count	590 Count	10 Count
1777790650	34 Count	564 Count	10 Count
1777789749	33 Count	548 Count	10 Count
1777788848	30 Count	526 Count	10 Count
1777787947	29 Count	505 Count	10 Count
1777787046	28 Count	481 Count	10 Count
1777786144	27 Count	454 Count	10 Count
1777785243	23 Count	423 Count	9 Count
1777784342	22 Count	394 Count	9 Count
1777783441	20 Count	364 Count	8 Count
1777782540	18 Count	333 Count	7 Count
1777781640	15 Count	293 Count	7 Count
1777780738	12 Count	246 Count	6 Count
1777778936	8 Count	166 Count	4 Count
1777778035	5 Count	139 Count	3 Count
1777777134	3 Count	101 Count	2 Count
1777776233	1 Count	51 Count	1 Count
1777775332	62 Count	1038 Count	22 Count
1777774431	59 Count	984 Count	21 Count
1777773552	53 Count	946 Count	20 Count
1777771751	49 Count	853 Count	18 Count
1777769949	44 Count	769 Count	16 Count
1777769048	42 Count	714 Count	15 Count
1777768147	40 Count	679 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)