EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773874191	203 Count	498 Count
1773873290	202 Count	495 Count
1773872389	201 Count	493 Count
1773871489	200 Count	490 Count
1773870588	199 Count	486 Count
1773869687	198 Count	483 Count
1773868786	197 Count	481 Count
1773867886	196 Count	478 Count
1773866985	195 Count	474 Count
1773866084	194 Count	471 Count
1773865183	193 Count	469 Count
1773864283	192 Count	466 Count
1773863382	191 Count	463 Count
1773862481	190 Count	460 Count
1773861580	189 Count	458 Count
1773860679	188 Count	455 Count
1773859779	187 Count	452 Count
1773858896	182 Count	449 Count
1773857995	181 Count	447 Count
1773857094	180 Count	444 Count
1773856193	179 Count	440 Count
1773855293	178 Count	437 Count
1773854392	177 Count	435 Count
1773853491	176 Count	432 Count
1773852590	175 Count	429 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)