EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8PDY-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8PDY-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773889914	134 Count	629 Count	121 Count
1773888113	122 Count	585 Count	110 Count
1773886313	114 Count	533 Count	103 Count
1773884518	95 Count	470 Count	89 Count
1773882717	87 Count	428 Count	82 Count
1773880917	75 Count	378 Count	71 Count
1773879116	66 Count	333 Count	63 Count
1773877316	54 Count	276 Count	52 Count
1773875515	46 Count	219 Count	45 Count
1773873714	19 Count	115 Count	19 Count
1773871914	166 Count	1076 Count	148 Count
1773870113	143 Count	986 Count	126 Count
1773868313	134 Count	935 Count	118 Count
1773866512	122 Count	861 Count	107 Count
1773864711	114 Count	804 Count	100 Count
1773862917	88 Count	686 Count	79 Count
1773861116	77 Count	632 Count	69 Count
1773859315	69 Count	575 Count	62 Count
1773857515	63 Count	506 Count	57 Count
1773855714	53 Count	368 Count	48 Count
1773853913	46 Count	280 Count	42 Count
1773852113	35 Count	228 Count	32 Count
1773850312	28 Count	180 Count	26 Count
1773848512	11 Count	98 Count	10 Count
1773846711	5 Count	49 Count	5 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)