EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769936276	137 Count	521 Count	125 Count
1769934475	89 Count	288 Count	82 Count
1769932674	68 Count	206 Count	62 Count
1769930874	40 Count	133 Count	35 Count
1769929073	20 Count	65 Count	16 Count
1769927280	305 Count	1019 Count	286 Count
1769925480	288 Count	962 Count	270 Count
1769923679	269 Count	890 Count	252 Count
1769921878	248 Count	821 Count	232 Count
1769920077	228 Count	747 Count	213 Count
1769918277	209 Count	674 Count	195 Count
1769916476	190 Count	607 Count	177 Count
1769914675	173 Count	543 Count	161 Count
1769912875	154 Count	481 Count	143 Count
1769911074	138 Count	432 Count	128 Count
1769909273	119 Count	366 Count	110 Count
1769907472	99 Count	297 Count	91 Count
1769905680	76 Count	242 Count	73 Count
1769903879	57 Count	169 Count	55 Count
1769902078	38 Count	114 Count	37 Count
1769900277	19 Count	58 Count	19 Count
1769898477	384 Count	1015 Count	368 Count
1769896676	366 Count	960 Count	351 Count
1769894875	347 Count	906 Count	333 Count
1769893074	327 Count	840 Count	314 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)