EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PA1MT-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA1MT-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773873917	146 Count	320 Count
1773872114	145 Count	317 Count
1773870310	144 Count	314 Count
1773868507	143 Count	311 Count
1773866703	142 Count	308 Count
1773864900	141 Count	305 Count
1773857686	137 Count	295 Count
1773855921	132 Count	293 Count
1773854117	131 Count	290 Count
1773852314	130 Count	287 Count
1773850511	129 Count	284 Count
1773848707	128 Count	281 Count
1773846904	127 Count	278 Count
1773845101	126 Count	275 Count
1773843297	125 Count	272 Count
1773841494	124 Count	269 Count
1773836084	121 Count	261 Count
1773834318	116 Count	259 Count
1773832515	115 Count	257 Count
1773830711	114 Count	254 Count
1773828908	113 Count	251 Count
1773827105	112 Count	248 Count
1773825301	111 Count	245 Count
1773823498	110 Count	242 Count
1773821695	109 Count	239 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)