EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772367686	220 Count	505 Count	164 Count
1772366786	216 Count	497 Count	161 Count
1772365885	212 Count	489 Count	158 Count
1772364984	208 Count	482 Count	155 Count
1772364083	204 Count	474 Count	152 Count
1772363182	200 Count	467 Count	149 Count
1772362282	196 Count	460 Count	146 Count
1772361381	194 Count	456 Count	145 Count
1772360480	191 Count	451 Count	143 Count
1772359579	188 Count	446 Count	141 Count
1772358679	185 Count	441 Count	139 Count
1772357778	178 Count	429 Count	133 Count
1772356877	175 Count	424 Count	131 Count
1772355976	172 Count	418 Count	129 Count
1772355076	169 Count	412 Count	127 Count
1772354175	166 Count	406 Count	125 Count
1772353274	162 Count	399 Count	122 Count
1772352373	158 Count	392 Count	119 Count
1772351472	154 Count	385 Count	116 Count
1772350572	150 Count	374 Count	113 Count
1772349671	146 Count	364 Count	110 Count
1772348770	142 Count	357 Count	107 Count
1772347869	137 Count	347 Count	103 Count
1772346969	132 Count	332 Count	99 Count
1772346068	128 Count	319 Count	96 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)