EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773886746	312 Count	892 Count	15 Count
1773884945	308 Count	869 Count	15 Count
1773883144	303 Count	846 Count	14 Count
1773881343	299 Count	833 Count	14 Count
1773879542	295 Count	809 Count	14 Count
1773877741	290 Count	785 Count	13 Count
1773875940	286 Count	773 Count	13 Count
1773874139	281 Count	757 Count	12 Count
1773872337	277 Count	741 Count	12 Count
1773870536	272 Count	721 Count	12 Count
1773868733	268 Count	706 Count	11 Count
1773866920	264 Count	693 Count	11 Count
1773865177	260 Count	679 Count	11 Count
1773863379	255 Count	665 Count	10 Count
1773861574	250 Count	649 Count	10 Count
1773859773	246 Count	633 Count	10 Count
1773857972	242 Count	619 Count	10 Count
1773856171	234 Count	605 Count	10 Count
1773854370	230 Count	592 Count	10 Count
1773852569	222 Count	579 Count	10 Count
1773850765	218 Count	559 Count	10 Count
1773848964	212 Count	533 Count	10 Count
1773847163	196 Count	520 Count	10 Count
1773845362	189 Count	504 Count	10 Count
1773843560	180 Count	476 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)