EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773781840	117 Count	819 Count	68 Count
1773780877	113 Count	798 Count	65 Count
1773780483	112 Count	791 Count	65 Count
1773779519	110 Count	770 Count	64 Count
1773778555	108 Count	753 Count	63 Count
1773777590	106 Count	735 Count	62 Count
1773776627	104 Count	716 Count	61 Count
1773775663	101 Count	698 Count	59 Count
1773774699	99 Count	682 Count	58 Count
1773773735	96 Count	662 Count	56 Count
1773772771	93 Count	648 Count	54 Count
1773771807	91 Count	631 Count	53 Count
1773770843	89 Count	614 Count	52 Count
1773769879	86 Count	595 Count	50 Count
1773768915	84 Count	578 Count	49 Count
1773767951	81 Count	561 Count	47 Count
1773766987	79 Count	545 Count	46 Count
1773766024	76 Count	529 Count	44 Count
1773765060	73 Count	512 Count	42 Count
1773764096	71 Count	497 Count	41 Count
1773763132	68 Count	483 Count	39 Count
1773762168	66 Count	465 Count	38 Count
1773761204	65 Count	441 Count	38 Count
1773760241	63 Count	422 Count	37 Count
1773759277	59 Count	399 Count	34 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)