EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777466538	200 Count	152 Count	18 Count
1777464737	177 Count	136 Count	17 Count
1777462937	150 Count	123 Count	16 Count
1777461136	132 Count	110 Count	15 Count
1777459336	114 Count	96 Count	14 Count
1777457535	94 Count	77 Count	13 Count
1777455734	47 Count	36 Count	6 Count
1777453934	13 Count	11 Count	1 Count
1777452133	1010 Count	459 Count	45 Count
1777450333	986 Count	447 Count	44 Count
1777448532	951 Count	412 Count	43 Count
1777446739	939 Count	404 Count	42 Count
1777444938	928 Count	395 Count	41 Count
1777443138	914 Count	387 Count	40 Count
1777441337	885 Count	379 Count	39 Count
1777439536	844 Count	366 Count	38 Count
1777437736	798 Count	352 Count	37 Count
1777435935	762 Count	336 Count	36 Count
1777434135	729 Count	325 Count	35 Count
1777432334	688 Count	313 Count	34 Count
1777430533	634 Count	301 Count	33 Count
1777428733	611 Count	292 Count	32 Count
1777426932	589 Count	280 Count	31 Count
1777425139	575 Count	269 Count	30 Count
1777423338	562 Count	261 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)