EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777475470	23 Count	773 Count
1777473669	22 Count	742 Count
1777471868	21 Count	719 Count
1777470068	20 Count	690 Count
1777468267	19 Count	654 Count
1777466466	18 Count	639 Count
1777464666	17 Count	611 Count
1777462865	16 Count	574 Count
1777461064	15 Count	547 Count
1777459263	14 Count	523 Count
1777457463	13 Count	499 Count
1777455671	12 Count	471 Count
1777453870	11 Count	447 Count
1777452069	10 Count	425 Count
1777450269	9 Count	400 Count
1777448468	8 Count	373 Count
1777446667	7 Count	349 Count
1777444866	6 Count	323 Count
1777443066	5 Count	286 Count
1777441265	4 Count	252 Count
1777439464	3 Count	220 Count
1777437664	2 Count	182 Count
1777435863	1 Count	123 Count
1777434071	0 Count	64 Count
1777432271	22 Count	1001 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)