EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772524160	47 Count	447 Count	36 Count
1772523259	38 Count	380 Count	28 Count
1772522358	35 Count	330 Count	26 Count
1772521474	25 Count	248 Count	21 Count
1772520573	18 Count	158 Count	15 Count
1772519673	17 Count	153 Count	15 Count
1772518772	12 Count	127 Count	11 Count
1772517871	7 Count	59 Count	7 Count
1772516069	102 Count	991 Count	87 Count
1772515169	91 Count	911 Count	77 Count
1772514268	86 Count	851 Count	73 Count
1772513367	80 Count	796 Count	68 Count
1772512466	73 Count	726 Count	62 Count
1772511566	67 Count	659 Count	57 Count
1772510665	61 Count	600 Count	52 Count
1772509764	55 Count	550 Count	47 Count
1772508864	50 Count	477 Count	43 Count
1772507963	43 Count	387 Count	37 Count
1772507062	37 Count	337 Count	32 Count
1772506162	31 Count	253 Count	27 Count
1772505261	27 Count	202 Count	24 Count
1772504360	21 Count	158 Count	19 Count
1772503460	14 Count	110 Count	13 Count
1772502559	6 Count	54 Count	6 Count
1772501658	109 Count	1006 Count	88 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)