EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3BKL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3BKL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773891709	318 Count	867 Count	88 Count
1773889908	312 Count	853 Count	86 Count
1773888107	306 Count	842 Count	84 Count
1773886306	299 Count	827 Count	81 Count
1773884505	292 Count	814 Count	79 Count
1773882704	286 Count	800 Count	77 Count
1773880903	280 Count	785 Count	75 Count
1773879102	274 Count	770 Count	73 Count
1773877301	268 Count	756 Count	71 Count
1773875500	262 Count	742 Count	69 Count
1773873700	255 Count	727 Count	67 Count
1773871899	249 Count	715 Count	65 Count
1773870098	243 Count	700 Count	63 Count
1773868297	237 Count	677 Count	61 Count
1773866496	231 Count	657 Count	59 Count
1773864695	224 Count	634 Count	56 Count
1773862893	218 Count	619 Count	54 Count
1773861093	212 Count	585 Count	52 Count
1773859292	205 Count	562 Count	50 Count
1773857491	198 Count	534 Count	48 Count
1773855690	189 Count	503 Count	46 Count
1773853889	179 Count	464 Count	44 Count
1773852088	167 Count	432 Count	42 Count
1773850287	159 Count	394 Count	40 Count
1773848510	148 Count	359 Count	38 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)