EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777739555	59 Count	1009 Count
1777737751	58 Count	977 Count
1777735947	57 Count	950 Count
1777732340	55 Count	891 Count
1777730536	54 Count	851 Count
1777728732	53 Count	820 Count
1777725167	47 Count	768 Count
1777719756	44 Count	709 Count
1777716148	42 Count	670 Count
1777712540	40 Count	643 Count
1777710736	39 Count	633 Count
1777708933	38 Count	619 Count
1777707129	37 Count	601 Count
1777705325	36 Count	576 Count
1777703564	31 Count	548 Count
1777701761	30 Count	523 Count
1777699957	29 Count	495 Count
1777696349	27 Count	444 Count
1777690937	24 Count	373 Count
1777689133	23 Count	351 Count
1777687330	22 Count	330 Count
1777685526	21 Count	307 Count
1777683722	20 Count	283 Count
1777680157	14 Count	235 Count
1777669334	8 Count	101 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)