EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777737223	509 Count	912 Count	396 Count
1777735852	493 Count	888 Count	382 Count
1777735241	486 Count	876 Count	377 Count
1777734635	478 Count	864 Count	371 Count
1777734029	469 Count	855 Count	365 Count
1777733423	465 Count	847 Count	363 Count
1777732816	455 Count	833 Count	355 Count
1777732210	448 Count	822 Count	350 Count
1777731604	437 Count	809 Count	344 Count
1777730998	421 Count	792 Count	335 Count
1777730391	411 Count	776 Count	328 Count
1777729785	403 Count	761 Count	322 Count
1777729179	392 Count	740 Count	313 Count
1777727966	374 Count	704 Count	299 Count
1777727361	363 Count	684 Count	290 Count
1777726754	356 Count	667 Count	284 Count
1777726148	346 Count	649 Count	275 Count
1777725539	337 Count	633 Count	267 Count
1777724933	331 Count	620 Count	262 Count
1777724327	328 Count	610 Count	260 Count
1777723720	319 Count	593 Count	253 Count
1777723114	305 Count	573 Count	241 Count
1777722508	295 Count	561 Count	232 Count
1777721902	284 Count	545 Count	224 Count
1777721296	276 Count	530 Count	218 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)