EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777794870	41 Count	967 Count
1777793069	40 Count	931 Count
1777791268	39 Count	903 Count
1777789467	38 Count	873 Count
1777787666	37 Count	843 Count
1777785865	36 Count	809 Count
1777784075	34 Count	778 Count
1777782274	33 Count	751 Count
1777780473	30 Count	718 Count
1777778672	29 Count	688 Count
1777776871	28 Count	666 Count
1777775070	27 Count	634 Count
1777773269	26 Count	610 Count
1777771468	25 Count	581 Count
1777769667	24 Count	556 Count
1777767866	23 Count	530 Count
1777766065	22 Count	501 Count
1777764264	21 Count	472 Count
1777762474	20 Count	454 Count
1777760673	19 Count	431 Count
1777758872	18 Count	410 Count
1777757071	17 Count	389 Count
1777755270	16 Count	364 Count
1777753469	15 Count	341 Count
1777751668	14 Count	312 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)