EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

M0MXL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0MXL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773863892	736 Count	842 Count	574 Count
1773862088	732 Count	837 Count	571 Count
1773860284	729 Count	835 Count	569 Count
1773858480	725 Count	830 Count	566 Count
1773856676	720 Count	824 Count	562 Count
1773854872	716 Count	819 Count	559 Count
1773853115	711 Count	813 Count	555 Count
1773851311	707 Count	807 Count	552 Count
1773849507	702 Count	801 Count	548 Count
1773847703	698 Count	796 Count	545 Count
1773845899	693 Count	791 Count	541 Count
1773844095	689 Count	786 Count	538 Count
1773842291	684 Count	780 Count	534 Count
1773840487	680 Count	775 Count	531 Count
1773838683	675 Count	771 Count	527 Count
1773836879	671 Count	767 Count	524 Count
1773835075	666 Count	762 Count	520 Count
1773833271	662 Count	757 Count	517 Count
1773831516	657 Count	751 Count	513 Count
1773829712	653 Count	746 Count	510 Count
1773827908	648 Count	740 Count	506 Count
1773826105	644 Count	735 Count	503 Count
1773824301	639 Count	729 Count	499 Count
1773822497	635 Count	724 Count	496 Count
1773820693	630 Count	719 Count	492 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)