EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777465194	217 Count	780 Count	140 Count
1777464308	210 Count	771 Count	137 Count
1777463408	207 Count	764 Count	135 Count
1777462507	204 Count	757 Count	133 Count
1777461606	202 Count	750 Count	132 Count
1777460706	199 Count	744 Count	130 Count
1777459805	196 Count	736 Count	128 Count
1777458905	191 Count	717 Count	124 Count
1777458004	188 Count	710 Count	122 Count
1777457103	182 Count	693 Count	117 Count
1777456203	176 Count	684 Count	113 Count
1777455302	173 Count	675 Count	111 Count
1777454401	171 Count	669 Count	110 Count
1777453501	168 Count	661 Count	108 Count
1777452600	165 Count	637 Count	106 Count
1777451699	162 Count	631 Count	104 Count
1777450799	159 Count	624 Count	102 Count
1777449898	156 Count	614 Count	100 Count
1777448997	154 Count	606 Count	99 Count
1777448097	151 Count	593 Count	97 Count
1777447196	148 Count	580 Count	95 Count
1777446295	144 Count	568 Count	92 Count
1777445395	142 Count	558 Count	91 Count
1777444494	140 Count	545 Count	90 Count
1777443594	135 Count	524 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)