EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777600196	452 Count	925 Count	416 Count
1777599293	440 Count	898 Count	405 Count
1777598390	426 Count	872 Count	392 Count
1777597486	413 Count	847 Count	380 Count
1777596583	400 Count	823 Count	368 Count
1777595680	389 Count	799 Count	358 Count
1777594776	377 Count	777 Count	347 Count
1777593873	366 Count	750 Count	337 Count
1777592970	353 Count	722 Count	325 Count
1777592066	341 Count	695 Count	314 Count
1777591161	329 Count	665 Count	303 Count
1777590257	319 Count	637 Count	294 Count
1777589354	304 Count	608 Count	280 Count
1777588533	293 Count	586 Count	270 Count
1777587629	280 Count	563 Count	258 Count
1777586726	268 Count	538 Count	247 Count
1777585822	255 Count	510 Count	235 Count
1777584919	240 Count	487 Count	221 Count
1777584016	221 Count	450 Count	203 Count
1777583112	210 Count	428 Count	193 Count
1777582209	195 Count	402 Count	179 Count
1777581306	184 Count	362 Count	169 Count
1777580402	170 Count	338 Count	156 Count
1777579499	154 Count	309 Count	141 Count
1777578595	142 Count	288 Count	130 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)