EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR8RZE-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8RZE-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1777455314	223 Count	948 Count	158 Count
1777454413	219 Count	933 Count	156 Count
1777453526	214 Count	923 Count	155 Count
1777452626	212 Count	919 Count	154 Count
1777451725	209 Count	908 Count	152 Count
1777450825	206 Count	892 Count	150 Count
1777449924	204 Count	882 Count	149 Count
1777449024	197 Count	863 Count	143 Count
1777448123	195 Count	858 Count	142 Count
1777447222	192 Count	844 Count	140 Count
1777446322	190 Count	837 Count	139 Count
1777445421	181 Count	819 Count	131 Count
1777444520	178 Count	805 Count	129 Count
1777442719	173 Count	776 Count	126 Count
1777441818	167 Count	756 Count	121 Count
1777440918	164 Count	739 Count	119 Count
1777440017	161 Count	725 Count	117 Count
1777439117	154 Count	694 Count	111 Count
1777437316	141 Count	616 Count	100 Count
1777436415	138 Count	561 Count	98 Count
1777435514	136 Count	543 Count	97 Count
1777434614	130 Count	521 Count	92 Count
1777433713	127 Count	509 Count	90 Count
1777432812	123 Count	498 Count	88 Count
1777431925	118 Count	489 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)