EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

DL1KDA-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1KDA-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1777520686	394 Count	578 Count	361 Count
1777518882	384 Count	561 Count	352 Count
1777517082	376 Count	545 Count	345 Count
1777515278	366 Count	529 Count	336 Count
1777513471	356 Count	511 Count	327 Count
1777511667	347 Count	494 Count	319 Count
1777509863	336 Count	475 Count	309 Count
1777508059	327 Count	459 Count	301 Count
1777506254	318 Count	443 Count	293 Count
1777504450	308 Count	426 Count	284 Count
1777502647	300 Count	411 Count	277 Count
1777500842	290 Count	394 Count	268 Count
1777499038	280 Count	378 Count	259 Count
1777497234	272 Count	363 Count	252 Count
1777495430	262 Count	347 Count	243 Count
1777493626	253 Count	329 Count	235 Count
1777491822	244 Count	312 Count	227 Count
1777490018	236 Count	296 Count	220 Count
1777488214	225 Count	279 Count	210 Count
1777486410	215 Count	262 Count	201 Count
1777484606	206 Count	247 Count	193 Count
1777482802	196 Count	232 Count	184 Count
1777480998	186 Count	219 Count	175 Count
1777479194	177 Count	203 Count	167 Count
1777477390	167 Count	191 Count	158 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)