EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773877528	744 Count	741 Count	400 Count
1773875727	743 Count	741 Count	400 Count
1773873927	742 Count	741 Count	400 Count
1773872125	741 Count	741 Count	400 Count
1773870325	740 Count	741 Count	400 Count
1773868524	739 Count	741 Count	400 Count
1773866723	738 Count	741 Count	400 Count
1773864923	737 Count	741 Count	400 Count
1773863123	736 Count	741 Count	400 Count
1773859527	730 Count	741 Count	400 Count
1773857727	703 Count	715 Count	374 Count
1773855926	668 Count	681 Count	340 Count
1773854125	667 Count	681 Count	340 Count
1773852325	658 Count	673 Count	332 Count
1773848723	655 Count	667 Count	331 Count
1773846923	654 Count	661 Count	331 Count
1773845122	642 Count	649 Count	320 Count
1773843322	641 Count	649 Count	320 Count
1773841520	640 Count	648 Count	320 Count
1773839720	639 Count	648 Count	320 Count
1773837927	634 Count	648 Count	320 Count
1773836126	633 Count	648 Count	320 Count
1773834325	632 Count	648 Count	320 Count
1773832525	631 Count	648 Count	320 Count
1773830724	630 Count	648 Count	320 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)