EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1777804530	101 Count	302 Count	71 Count
1777802729	95 Count	285 Count	66 Count
1777800928	92 Count	277 Count	64 Count
1777799128	89 Count	268 Count	62 Count
1777797327	86 Count	259 Count	60 Count
1777795526	83 Count	249 Count	58 Count
1777793725	80 Count	238 Count	56 Count
1777791932	77 Count	229 Count	54 Count
1777790131	74 Count	221 Count	52 Count
1777788330	71 Count	203 Count	50 Count
1777786529	68 Count	195 Count	48 Count
1777784729	65 Count	185 Count	46 Count
1777782928	62 Count	177 Count	44 Count
1777781127	56 Count	165 Count	39 Count
1777779327	53 Count	157 Count	37 Count
1777777526	50 Count	149 Count	35 Count
1777775725	47 Count	141 Count	33 Count
1777773925	44 Count	133 Count	31 Count
1777772124	41 Count	117 Count	29 Count
1777770331	38 Count	105 Count	27 Count
1777768530	35 Count	97 Count	25 Count
1777766729	32 Count	89 Count	23 Count
1777764928	29 Count	81 Count	21 Count
1777763128	26 Count	73 Count	19 Count
1777761327	23 Count	60 Count	17 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)