EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1777810747	582 Count	857 Count
1777808946	578 Count	852 Count
1777807145	574 Count	848 Count
1777805344	570 Count	843 Count
1777803544	566 Count	838 Count
1777801743	562 Count	834 Count
1777799942	558 Count	829 Count
1777798142	554 Count	825 Count
1777796341	550 Count	820 Count
1777794540	546 Count	814 Count
1777792739	542 Count	810 Count
1777790938	538 Count	805 Count
1777789147	534 Count	801 Count
1777787346	530 Count	797 Count
1777785546	526 Count	793 Count
1777783745	522 Count	788 Count
1777781944	518 Count	778 Count
1777780143	514 Count	772 Count
1777778343	510 Count	767 Count
1777776542	506 Count	765 Count
1777774740	502 Count	759 Count
1777772939	498 Count	752 Count
1777771139	494 Count	746 Count
1777769338	490 Count	737 Count
1777767547	486 Count	729 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)